Procedure with the file for the DCI 700 and DCI 200 received by mail.
The file will not be found in your account downloads after purchase.
You will receive the file from monday till Friday within 12 hours by email. Please make sure to use the correct email address.
ATTENTION!
All files that you can purchase for the DCI 700 or DCI 200 are linked to your test bench serial number.
For this reason, you must enter the correct serial number of your DCI 700 or DCI 200 test bench during the ordering process.
PLEASE NOTE THIS!
Here you can download the instructions as a PDF.
CAUTION! This application works only with software stand V2.03, firmware stand 1.21 or higher on the EPS 200
At first the file must be unzipped and copy the folder to an USB Stick. At next put the stick on the EPS 200 and open the folder. Now you have to double click the file "UpdateEPS200DB.exe".
The #-sign at the end of Denso-Numbers represent a Joker-Position. It can be replaced by the numbers 0 to 9.
Working with the downloaded file EPS 205.
CAUTION! This application works only with software stand V2.03, firmware stand 1.21 or higher on the EPS 205
At first the file must be unzipped and copy the folder to an USB Stick. At next put the stick on the EPS 205 and open the folder. Now you have to double click the file "UpdateEPS200DB.exe".
The #-sign at the end of Denso-Numbers represent a Joker-Position. It can be replaced by the numbers 0 to 9.
Working with the downloaded file EPS 815/708.
Caution!! Functionality of the test plans from software EPS 945 V 3.45 guaranteed.
Please be sure to perform step 1 first.
1. Save the file after downloading:
The file must be unzipped and placed in a folder after downloading. The best course of action is to use the number of the part to be tested as the folder name. Please be sure to save this folder in your computer as only one test plan can be saved in the test rig and the testing software. If you do not have an unzipping program, one can be downloaded from ”Download 7-Zip“ on the home page.
2. Installing the folder on the test rig:
Copy the file with the number needed for the test plan onto the test rig’s hard disc (C:/). The next stage is to open the folder and to double click on the file “install.bat“ you will find there. Now launch the tes software and proceed as far as the component selection template. Do not enter a number here but press the F2 key and select “Esitronic CDW“. The required component number will appear in the selection and you can proceed as usual.
IMPORTANT You must follow these steps before every new test of an external component as only one test plan can be saved in the test software. This means that when you install another test plan, the previous one is automatically deleted.
The #-sign at the end of Denso-Numbers represent a Joker-Position. It can be replaced by the numbers 0 to 9.